Otherwise, our DD-WRT repeater wont be able to establish the connection.And its free. Its packed with many features and various tools which can be quite useful.It supports many commercial grade routers(ASUS, Tp-Link, D-Link, Linksys etc).
Merlin Wifi Repeater Configuration Install It OnBasically what it does once you install it on your router, your router is then equipped with many tools that can often be found on enterprise grade routers. We already covered the installation process of DD-WRT on TP-Link routers, which you can check out here. Merlin Wifi Repeater Configuration How To Setup AAnd on this post we are going to cover the process how to setup a wifi repeater bridge in DD-WRT. Merlin Wifi Repeater Configuration Password For TheNecessary information to acquire before configuration There are couple of parameters that are necessary to acquire in order for this to work: Primary IP address of your current router which provides WiFi, From your primary router, you need to know the starting IP address from its DHCP server some routers start their IP pool from 192.168.1.100 or something like that, WiFi name(SSID) and its password, Encryption type of the password for the WiFi, WiFi network mode and channel width. All these information can be acquired once you login in your router and check for LAN or DHCP section and WLAN or Wireless section. WiFi repeater configuration Once you gather all that info and you installed DD-WRT on your router, login to the DD-WRT router. Its default IP address to access is 192.168.1.1. ![]() Make sure to write it down so you can access it later and to avoid reseting it to factory defaults. Open the Wireless tab and under that, navigate to the basic settings. First option Wireless mode, change it to Client bridge(Routed). For gateway field enter the primary address of your primary router of which we need to extend the WiFi. Wireless network mode and chanel width needs to be exact as on the primary router. Example my primary router works only in N mode and has channel width of 20 Mhz. Your router can have the same setup or it can have a mixed Wireless network mode(BGN) or just two Network modes. Wireless network name(SSID) field in there, enter the WiFi of your primary router, the WiFi you use and which we need to extend. On the bottom of the page, there is a section Virtual interfaces. Wireless Network Name SSID Set the name for the new extended WiFi. You can set a new WiFi name or you can set the name of the primary WiFi. Once you entered all the parameters, click on the Save changes button. WiFi repeater configuration WiFi security Next switch to the Wireless security tab. Here we need to provide the security parameters of our primary WiFi network and the new one. Like stated in the previous heading, for the WiFi security also, the security parameters in the first field must be the same as on our primary router.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |